Description
Valhalla – CZ P07-P09- P01 Omega Hammer
The new Valhalla 2.0 is designed with concealed carry in mind, so it is as small as possible, with no sharp or uncomfortable edges. The Valhalla 2.0 gives you a crisp (SA) Single Action break and a more consistent (DA) Double Action trigger pull.
Made from precision CNC’ed solid billet 4140 steel.
Hardened to perfection, with DLC coating.
Works with factory parts.
Comes with an upgraded set of sears springs, to fine-tune your trigger break.
The pin that retains the hammer strut fits in easily and is held in place by the pressure of the hammer spring. When installing, make sure that the pin is centered, as the center is slightly larger than the two edges.
An oversized trigger bar disconnector might be needed to help with the timing.
When decocking, don’t let the hammer slam into your sear (causes undue wear); instead, use your thumb to guide the hammer into place using both hands. Use one thumb to guide the hammer, and the other to manipulate the decocker. If you just slam the hammer into the sear, it might skip the decocking position (this is not dangerous as the firing pin block stops accidental discharges when the trigger is not pulled). When designing the hammer, the priority was on the trigger/ hammer feel, and performance, so compromises needed to be made; so the hammer is not designed to slam down into the decocked position. If you have questions about this, please ask questions.
